%% material 3mm crylic, main laser
%cant see any warping, top n bottom meassurements less than .1 mm apart
hole = 94.79;
pcs = [4.86 4.92 4.87   4.83 4.85 4.93 4.89 4.88 4.86 4.87 4.83 4.9 4.78 4.86 4.85 4.86 4.82 4.86 4.84];

meas_kerf = ((hole - sum(pcs))/(length(pcs) + 1))


%% material 3mm mdf, main laser
hole = 94.84;
pcs = [4.88 4.86 4.86 4.87  4.85 4.88 4.84 4.83 4.82 4.89 4.82 4.88 4.85 4.86 4.84 4.86 4.85 4.89 4.86];
%                             4.85 4.85 4.82 4.84 4.85 4.82 4.86 4.89 4.88 4.87 4.87 4.85 4.84 4.86 4.81];
meas_kerf = ((hole - sum(pcs))/(length(pcs) + 1))

%% material acrylic 3mm, small laser, freq 1500
% material warped slightly, cut is horrible.there is a clear trappezoidal shape
% cut is more at top than at bottom, top is as low as 4.7 and bottom is as
% wide as 5.1
hole = 94.84;
pcs = [4.7 4.8 4.7 4.65 4.7 4.66 4.68 4.69 4.66 4.65 4.75 4.67 4.71 4.7 4.71 4.69  4.8 4.71 4.73];

meas_kerf = ((hole - sum(pcs))/(length(pcs) + 1))

%% material acrylic 3mm, small laser, freq 500
% cant see any warping , cut is ok,
% same as previous, top 4.7 to 5 at bottom

hole = 94.7;
pcs = [4.71 4.72 4.7 4.7 4.73 4.67 4.71 4.66 4.76 4.69 4.74 4.7 4.7 4.7 4.71 4.69 4.67    4.65 4.76 ];

meas_kerf = ((hole - sum(pcs))/(length(pcs) + 1))

%% material acrylic 3mm, small laser, freq auto
% priminant warping , cut is ok,
% same as previous, top 4.7 to 4.9 at bottom

hole = 94.73;
pcs = [4.79 4.77 4.78 4.74 4.79 4.75 4.73 4.73 4.76 4.78 4.81 4.69 4.75 4.73 4.74 4.75 4.72 4.69 4.73];

meas_kerf = ((hole - sum(pcs))/(length(pcs) + 1))

